The Really Nice Pre-amp, the RNP, is a 1/3 rack two channel mic pre-amp. FMR's objectives for this pre-amp were:
- Relatively neutral sonics
- A Really Nice price ($499 msrp)
- Compatibility with the RNC/RNLA
We believe that the RNP is a good addition to any studio looking for an clean, full-sounding mic pre-amp.
Lots o' Headroom
These days, the trend is for microphones to increase their output signal levels while reducing their output noise levels. This means either employing a front-end pad and/or increasing the headroom of a mic pre. FMR decided to do the latter: at unity gain, the RNP 8380 has a clip point of +27.5dBu (almost 25Volts peak-to-peak)! Even with a hefty microphone output, the RNP8380 should take what your mics have to give.
When designing a pre-amp, there are many ways to balance the sometimes conflicting operating constraints. Unfortunately, with the proliferation of integrated-circuit (IC) based mic pres in recent years, one of the typical casualties has been fidelity. At this point, I won't bore you with the geeky details, but I want to assure you that fidelity was not sacrificed in the RNP8380. Even though there are many mic pres that are quieter, there are very few that have the spurious-free (i.e., distortion-free) spectrum of the RNP8380. Now, more than ever, what you put into a mic pre is what you'll get out.
If you look beyond the RNP8380's utilitarian ugliness, you'll see that FMR opted to throw the money they saved in cosmetics into the quality of the audio electronics. We all like having nice-looking gear as much as the next guy, but given the choice between something that sounds nice versus looks nice, the sound wins out everytime.
Really Nice Compressor (RNC) Inserts
Each channel on the RNP8380 has an unbalanced send/receive jack that allow you to connect an RNC1773 using a single Tip-Ring-Sleeve (TRS) cable (per channel). With proper cabling, you could also use this feature to balance any other unbalanced piece of gear. In addition, with the right external configuration, the RNP can provide a separate +22dBu unbalanced output and a +28dBu balanced output simultaneously to allow nifty things like separate M/S decoding while tracking the M/S signal without decoding.
Both the mic inputs and mic pre outputs are electronically balanced, differential signals. Want to run to/from unbalanced sources? No problem, the RNP automatically adjusts...no special cabling required.
Balance an RNC
Using the above features, you can allow/provide a balanced signal to/from an RNC/RNP set.
Hi-Z DI inputs
These inputs are designed to take a source, such as a passive bass, and not "suck the tone" away from the instrument. This input features a high-impedance unbalanced 1/4" jack.
Slowly-Ramping 48V Supply
During phantom engagement/disengagement and DI/mic switching, the output signals are momentarily muted to reduce output pops & clicks that may otherwise annoy you and others. This mute actually occurs before the insert send signal, so even devices connected to the insert are spared large pops & clicks.
Stepped Gain Control
To allow precise gain-setting between multiple channels, FMR is using a Grayhill 12 position switch to set the RNP's gain.
Phase Inversion Control
This is fairly standard stuff to allow you to accommodate any phase problems due to things like system cabling, etc.
Three LEDs are provided for metering each channel (signal presence, +18dBu and CLIP). In addition, the clip LED trips at 1dB below actual clip and stays on for 3 seconds to make signal-chain troubleshooting easier. The metering is digitally-calibrated and driven by the internal microprocessor.
Flexible Power Supply Requirements
The RNP will run off of either AC or DC as long as the voltage range is within 9-12V (and has a current capacity of at least 1.5Amps). Polarity of the wallwart connection is unimportant so that you don't have to worry about that detail either. In addition, if you happen to connect a wallwart that doesn't have enough oomph to power the RNP (like the RNC's wallwart), the RNP will tell you by periodically flashing it's front panel LEDs.
The includes a 1 Year return to base warranty. This warranty applies to all equipment which has developed a manufacturer defect during application. Please contact us to confirm the availability and lowest price for any product. For quotes and price matching requests, contact us and include the competing website address.
|Condition||Sealed / New|
|Free Shipping||Hong Kong|
|Delivered HKD Price||Shown at checkout|
Look no further than AudioBuy when buying gear online in Hong Kong , always at the lowest price with free shipping to all locations serviced by FEDEX. Please contact us for stock availability , price quotes , expedited shipping quotes or to arrange a return of your (for the full purchase price of ). You may return most new, unopened items within 30 days of delivery for a full refund. AudioBuy Hong Kong are very proud to carry a large selection of gear. You demand quality, reliability, and innovative design from your gear, and we're here to help you find exactly what you need. We're glad to answer any questions you have and you can always depend on AudioBuy Hong Kong to give you the best possible value on musical instruments and accessories with responsive customer service.
All payments are processed securely by Paypal , offering both buyer and seller protection. Online orders are confirmed in stock and ready to ship before Paypal payment is completed. orders ship FEDEX and will require signature upon delivery. Orders are typically delivered within 4-5 business days following dispatch. Fedex tracking details are provided for all orders.
Hong Kong is a free port and does not levy any duty on imports (or exports). There is also no sales tax or other import charges. The total delivered price for delivery to Hong Kong will be . Detailed information on import declaration procedures and import restrictions can be found at the Hong Kong Customs website.
- Buy products with confidence.
- Ships to most locations in Hong Kong including Kowloon , Tsuen Wan and Yuen Long.
- Return to base repair or replacement (1 Year return to base).
- Please contact AudioBuy.hk Hong Kong for detailed information about our warranty terms and conditions.
There are zero import tax/duty charges into Hong Kong